1000C Reverse Osmosis Water Filter

HOW IT WORKS

In Stage 1, Water travels through a 1 micron solid carbon cartridge for removing volatile organic carbon compounds (VOC’s), insecticides, pesticides and industrial solvents also removes sediment, silt, sand and dirt. Also extends the life of the unit.

In Stage 2, Water travels through a .01 micron Ultrafiltration (UF) membrane. Ultrafiltration (UF) is an important purification technology used for the production of high-purity water. UF is effective for the removal of colloids, proteins, bacteria, viruses, parasites, protozoa and pyrogens (e.g., gram-negative bacterial endotoxins), other organic molecules larger than .01 micron, and most other water contaminants known today.

Click here to see how it works

In Stage 3, Water flows through pre one – micron filter pads (1 micron equals 1/25,000th of an inch), which remove suspended particles such as silt, sediment, cyst (Giardia, Cryptosporidium), sand, rust, dirt, and other undissolved matter .

In Stage 4 , Water passes through granulated activated carbon (GAC). GAC is universally recognized and widely used as an effective adsorbent for a wide variety of organic contaminants, such as chemicals linked to cancer (THM’s, benzine) pesticides, herbicides, insecticides, volatile organic compounds (VOC’s), PCB’s, MTBE’s and hundreds of other chemical contaminants that may be present in water, bad taste, and odors from your drinking water. Carbon is extremely porous and provides a large surface area for contaminants to collect. Carbon-only filters must also use their capacity for chlorine removal, resulting in a shortened life. They also may use a bituminous coal carbon, which is good at removing chlorine, but not as effective at removing chemicals. We use a high-grade coconut shell carbon that is most effective at removing chemicals. Coconut shell carbon provides a significantly higher volume of micro-pores than either coal, wood or lignite- based carbon. As a result, it is more effective than other carbon types in removing trihalomethanes (THM’s) and other chemicals from municipally supplied water. Since our REDOX media removes the chlorine before it reaches the carbon, the carbon capacity is not wasted on chlorine and is free to concentrate more effectively on organic contaminants.

In Stage 5, Water flows through the ion exchange resin, reducing heavy metals such as lead, copper, aluminum, and water hardness.Water flows through a bed of media made of a special high-purity alloy blend of two dissimilar metals – copper and zinc . it is a major advancement in water treatment technology that works on the electro-chemical and spontaneous-oxidation-reduction (REDOX) principles. Chlorine is instantaneously and almost inexhaustibly oxidized.Tests on the cartridge have shown 99+% chlorine removal past 20,000 gallons of water. In comparison, carbon cartridges of comparable volumes drop below 90% effectiveness after only 4,000 gallons.Iron and hydrogen sulfide are oxidized into insoluble matter and attach to the surface of the media. Heavy metals such as lead, mercury, copper, nickel, chromium, cadmium, aluminum, and other dissolved metals are removed from the water by the electrochemical process. They are attracted to the surface of the media, much like a magnet. The media inhibits bacterial growth throughout the entire unit. In fact, it has been shown to be reduced up to 90%, eliminating the need for silver, which is commonly used in carbon-only filters (silver is considered a pesticide by the EPA and, as such, must be registered with them).Is copper or zinc added to the water in any significant amount? On 2.3 ppm chlorinated water, & 0.05 mg/l copper and only 0.46 mg/l zinc were measured. The EPA aesthetic levels are 1.0 mg/l for copper and 5.0 mg/l for zinc. Both zinc and copper are essential minerals for good health – the FDA recommends a daily intake of 15 mg of zinc and 2 mg of copper

In Stage 8,Water flows through another one-micron filtration pad for further reduction of undesirable particles. The end result is a great reduction or elimination of a wide variety of contaminants.

In Stage 9, Water passes through a reverse osmosis membrane, which removes substantial amounts of most inorganic chemicals (such as salts, metals, minerals) most microorganisms including cryptosporidium and giardia, and most inorganic contaminant.

In Stage 10 and 12,  Water flows through another one – micron filter pads (1 micron equals 1/25,000th of an inch), which remove suspended particles such as silt, sediment, cyst (Giardia, Cryptosporidium), sand, rust, dirt, and other undissolved matter.

In Stage 11,Water passes through granulated activated carbon (GAC). GAC is universally recognized and widely used as an effective adsorbent for a wide variety of organic contaminants, such as chlorine (99.9%), chemicals linked to cancer (THM’s, benzine) pesticides, herbicides, insecticides, volatile organic compounds (VOC’s),  PCB’s, MTBE’s and hundreds of other chemical contaminants that may be present in water, bad taste, and odors from your drinking water.

Click here to learn more about GAC

In Stage 13, Water passes through an Ultraviolet Water Sterilizer System manufactured with axial flow reactors in 304 stainless steel. The hard glass germicidal lamps provide an economical way of treating water requiring a 99.99% reduction of bacteria and virus and protozoa. This process is accomplished without adding any harmful chemicals to your drinking water. CRYSTAL QUEST® Ultraviolet Water Sterilizer System is the most ecological way of treating your water.

*if present in the water

 
PureWaterHQ
4611 Bee Caves Rd
Austin TX 78746
877-595-8545